How to Use a Slide Head Swiss Type Machine

In addition to the many advantages of the Swiss type machine, there are some disadvantages as well. The most common drawback is that it takes a while for the machines to start working, and can be a great challenge for older people to move the machine around.

Slide Head Swiss type machine

You will need to start with the upper armature first before moving to the lower armature. Also, you may find that it may take a few times to get the machine set up properly so that it will operate the way it was designed to. But in general, it is not hard at all to use.

Make sure you turn the motor to on. In addition, you should unplug the motor and remove the plugs to the machine. Now you can attach the clamp onto the motor. You can either hold the clamp to the motor directly or you can turn the motor on and off with a screwdriver. You should also turn the distributor switch on and off.

Now you will need to put the armature needs into the machine. You will want to put the arms onto the tube of the machine.

With the armature in place you will now position the clamp over the armature so that the armature is fully centered in the tube. Then, you will want to give the clamp a slight forward and back motion so that the clamp holds the armature in place.

You will need to put the clamping plate on the clamping plate. However, before you put the clamping plate on, you will want to align the plate with the flat surface of the carriage. This is very important, and you will want to keep this in mind.

Now, youwill place the head machine onto the clamping plate. In addition, you will need to push the head forward until the plate is up against the carriage.

You will then need to tighten the screws holding the plate onto the head machine so that the plate is firmly held onto the upper armature. Then, you will need to put the head and armature onto the clamping plate.